Jabiru Owners Group

Welcome to the world of Jabiru

Screw holes for inspection covers

Post your general chit chat here. This is the only forum where POLLS are permitted.
  • Advertisement

Screw holes for inspection covers

Postby BobMcManus » Sun Sep 30, 2018 2:15 am

My J250 was built in 2004. After a number of condition inspections the holes for the screws holding the inspection covers are getting large. Wondering what others have done to address this issue. Have looked at the possibility of using rivnuts, but am not sure if they will hold in the fiberglass.
Posts: 2
Joined: Fri Sep 28, 2018 5:37 am
Aircraft: J259

Re: Screw holes for inspection covers

Postby diablo » Sun Sep 30, 2018 8:47 pm

Try using a touch of Araldite on the thread and don't overtighten screws when putting them back on. Once Araldite sets, the screw should be nicely held. the newly threaded Araldite should last a while. Alternatively, use rivnuts but beware when tightening/torquing up as they do end up loosening off.
Sent from my "Electronic Numerical Integrator And Calculator" E-N-I-A-C
User avatar
Site Admin
Site Admin
Posts: 374
Images: 1
Joined: Fri Feb 06, 2015 8:25 pm
Aircraft: Jabiru SK 2200A 1157

Return to General board

Who is online

Users browsing this forum: No registered users and 6 guests